Careers Document Access
News | Blog

Apache Stainless Blog


Apache Stainless Equipment Corporation


How to Troubleshoot a Pressure Tank

There are several reasons why a vessel may need service, however, two main causes why a vessel may need service are either accident or performance related.

In the case of an accident, such as a tool falling into the tank and causing damage; surface scratches and dents can typically be repaired on-site, provided they do not go beyond minimum requirements, with mechanical polishing or hand/wand electropolishing. 

Reduced agitator performance or failure is often due to worn parts, improper assembly or a bent or broken shaft.  Agitator repairs may be addressed with the agitator manufacturer or the vessel manufacturer, depending on the situation, down-time, and severity of the failure.

When troubleshooting a drop in pressure in a tank or vessel, a typical cause is often related to seals. One sign of seal failure is product coming out of the seal.  To help reduce the frequency of an unexpected seal leak occurring, it is recommended to use a good seal maintenance program to solve a lot of pressure / performance issues, such as:
•    Seal replacement has been neglected
•    Flat spots on seals are a sign for replacement
•    Improper or incorrect seals for the outlet
•    Nicks, scratches or mishandling of seals

A best practice is to avoid product waste and critical down-time is to inventory seals for all outlets and manage seals in a preventative maintenance program.

It is important to note that any weld repairs to the ASME pressures zones on tanks, require an R-Stamp.  The R-Stamp is a certification required by the National Board of Boiler and Pressure Vessels for repair of an ASME tank or vessel.

Depending on the size of the vessel and type of repair, Apache’s service techs may be able to make repairs on site or in some cases, tanks are shipped back to the factory. Apache can provide services including:
•    Field service and troubleshooting to all types of stainless and high alloy tanks
•    ASME / National Board R-Stamp repair and modifications
•    Surface finish repairs
•    Non-code repairs and modifications including piping and heat transfer jackets
•    Seal and agitation repairs and modifications
•    Accessory repairs
•    Head and tank shell repairs
•    Leak detection
•    Audit and service contract available

Visit Small Vessels

Visit Large Tanks


Subscribe To Our Blog

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Recent Posts

Read More »